Learn
Knowledge base
Field-verified guidance from the techs who service spray booths.
AMU pre-filter selection
Read article →
Aftermarket vs OEM filter economics
Read article →
Body shop vs industrial finishing filter selection
Read article →
Booth fan static pressure curves and filter loading
Read article →
Booth not pulling air diagnostic
Read article →
Booth pressure balancing fundamentals
Read article →
Dust nibs root cause troubleshooting
Read article →
EPA 6H paint booth compliance (NESHAP Subpart HHHHHH)
Read article →
Electrostatic powder cell maintenance
Read article →
End-of-life filter disposal compliance
Read article →
Energy efficiency: VFD + IR vs gas heating
Read article →
Filter cycle math by climate zone
Read article →
Filter media gram weight explained
Read article →
Fleet maintenance scheduling (multi-booth shops)
Read article →
HVLP vs airless: filter loading impact
The gun you spray with sets the rate your exhaust media loads. Here is how transfer efficiency translates into filter change cadence and spend. →
Hexavalent chromium filtration requirements
Read article →
High-solids coating cycle adjustments
Read article →
How often to replace paint booth filters
Read article →
How to measure your paint booth filter
Read article →
How to size a new paint booth (CFM, throughput, footprint)
Read article →
Intake vs exhaust filters: what each one does
Read article →
MERV ratings decoded
Read article →
Manometer pressure drop reading guide
Read article →
NESHAP Subpart GG aerospace 3-stage chromate filtration
Read article →
NESHAP Subpart IIII surface coating (major source)
Read article →
Orange peel finish defect troubleshooting
Read article →
Paint booth recordkeeping for state inspections
Read article →
Paint defects caused by dirty filters
Read article →
Polyester vs fiberglass exhaust media tradeoffs
Read article →
Pre-filter to final filter staging strategy
Read article →
Pressure-drop monitoring program (setup + cadence)
Stop changing filters by guesswork. A gauge, a log sheet, and a baseline reading turn filter replacement into a condition-based decision. →
Replace booth vs upgrade filters: the economics
A structured way to separate the booths that need capital from the booths that need a filter program, balance work, and a few targeted retrofits. →
Replacement filter compatibility cross-reference
Read article →
Shop-floor compliance walkthrough (mock NESHAP audit)
Every question a 6H inspection actually asks, in the order it gets asked, so the first person to find a gap is you. →
Subscription auto-replenish vs reorder economics
Read article →
Waterborne paint filter selection
Waterborne coatings dry by air movement instead of solvent flash, and that shift lands on your filters before it lands anywhere else. →
Wire grid vs no-grid exhaust filters
Read article →