Diagnostic · Narrowed down
6 likely matches
We narrowed it down. Pick the one that best matches what you're seeing for the full diagnostic + filter guidance.
Burner short-cycling during bake
Burner cycling on and off at short intervals during bake instead of holding a steady mid-fire output. Hits target then drops, repeating.
Severity: medium
Paint booth won't start after a power surge or power outage
The booth is completely dead or shows no normal startup sequence after an electrical disturbance.
Severity: low
Emergency stop won't release / booth won't restart
An emergency stop is holding the booth locked out even after being 'released'.
Severity: low
Paint booth cycling on and off unexpectedly
The booth is not staying in its run mode. It starts, then trips off, then tries to restart.
Severity: high
Burner fail to start (no ignition)
The booth burner isn't firing when it should.
Severity: medium
Flame failure fault during run
The flame ignites but doesn't stay lit reliably.
Severity: high
Show your answers
Is the problem a visible defect in the paint finish — dust nibs, orange peel, fisheyes, runs, or other surface defects?
→ No
Does the booth refuse to start, or shut itself down on its own during operation?
→ Yes
Is overspray clearly escaping the booth into the surrounding shop area?
→ No
Is the booth's pressure reading abnormal — manometer reading too high or too low, or staff notice the booth is pushing/pulling differently than normal?
→ No
Is the HMI or booth controls displaying a specific fault code or alarm (VFD fault, gas pressure, flame failure, intake motor feedback, filter pressure)?
→ No
Does the problem track with the WEATHER or season — worse on humid days, hot afternoons, or cold/dry winter mornings?
→ No
Is it specifically the FILTERS — loading too fast or slow, uneven, or a filter-bank pressure alarm (rather than weak airflow or a dead fan)?
→ No