The ecommerce arm of WERCS Inc, a paint booth service company in Kalama, Washington.

Diagnostic · Result

Looks like: Booth pressure too positive (pushing out)

Based on your 4 answers, the most likely cause is the symptom below. Open the symptom hub for the full diagnostic checks, recommended filter category, and service-escalation guidance.

Booth pressure too positive (pushing out)

The booth is pushing air OUT instead of pulling air IN. This is a compliance violation under NESHAP Subpart HHHHHH.

Severity: high

Open Booth pressure too positive (pushing out) →Start over
Show your answers

  1. Is the problem a visible defect in the paint finish — dust nibs, orange peel, fisheyes, runs, or other surface defects?

    → No

  2. Does the booth refuse to start, or shut itself down on its own during operation?

    → No

  3. Is overspray clearly escaping the booth into the surrounding shop area?

    → Yes

  4. Is the booth's pressure reading abnormal — manometer reading too high or too low, or staff notice the booth is pushing/pulling differently than normal?

    → Yes